How to Wire the PL1617 and PL1612 for 220V

Difficulty:

Intermediate

Tyler Aviles

February 17, 2025

When wiring the PL1617 and PL1612 it is quite simple. Just remember that the volt switch is what tells the motor what voltage is coming in. These pumps come pre-set to 220v on the switch. This is a step-by-step how-to guide for wiring the PL1617 and PL1612 to 220v.

Tools Needed:

Phillips head screwdriver
Needle nose pliers
Volt meter or non-contact volt meter

Supplies Needed:

Quick disconnects for wires
PL1617 or PL1612 pump

Step 1

Turn the Power off at the Breaker.

Turn off the power to the motor by flipping the breaker off.

Turn off breaker - DIY Pool Resources - INYOPools.com

Step 2

Make Sure the Power is Off

Using a volt meter or non-contact volt meter, check your wires coming from your power source to make sure there is no power going to them.

Checking for power - DIY Pool Resources - INYOPools.com

Step 3

Remove the Back Motor Cap

Unscrew the two screws on the back cap using a Philips screwdriver. Then pull the cap off gently, making sure you don’t accidentally disconnect any wires.